Install Guide – Enduro

Device Provisioning

1. The Enduro comes with a pre-installed SIM card and is provisioned on our GPS tracking platform.
   
2. Each device is checked for connectivity prior to being delivered to a client site.
   

WARNING: Do not disassemble the device, If the device is damaged, the power supply cables are not isolated or the isolation is damaged, DO NOT touch the device before unplugging the power supply.

Installation Tips

1. Standard installation is the connection of:
   
1. Power
   
2. Ground
3. Ignition source
2. The device should be mounted securely against a flat surface.
3. There should be no metal above the device.
4. The device should be mounted as far away from the radio and speakers as possible.
   
5. You can use the magnet shell for easy installation on a vehicle or asset, or you can use screws and bolts for a more permanent attachment, as required.
   
6. For a wired installation, access the vehicle's battery, loosen the terminal nuts, attach the red and black wires of the tracker to the positive and negative terminals, and then tighten the nuts and secure the tracker.
   

Wiring Harness

Pin Number	Colour	Pin Name	Description
1	White	Digital Input 1	Digital Input - can be configured as ACC/Ignition
2	Red	Power VCC	DC 12V
3	Black	Ground	Ground
4	Blue	Digital Output 1	Digital output

NOTE: Please refer to the vehicle or asset wiring information before wiring the device, to ensure that the correct wires are being connected.

Device Testing

On completion of the installation, please contact us on 1300 88 36 79 to allow us to check that the device is correctly functioning.

Please have the device IMEI number (printed on the device) and Customer Name ready.

• Related Articles

• Install Guide – Rugged+

  Device Provisioning The Rugged+ comes with a pre-installed SIM card and is provisioned on our GPS tracking platform. Each device is checked for connectivity prior to being delivered to a client site. The internal battery is switched off for transit ...

• Install Guide – Remote Worker

  Device Provisioning The Remote Worker comes with a pre-installed SIM card and is provisioned on our GPS tracking platform. Each device is checked for connectivity prior to being delivered to a client site. The device is not IP67 rated, so be cautious ...

• Install Guide – Rugged Tablet

  Device Provisioning The Rugged Tablet comes pre-installed with the relevant applications as per the customer requirements. The Rugged Tablet comes pre-configured to use the Accessory line of a vehicle to power and shutdown the tablet while in the ...

• Install Guide – Dash 4G

  Device Provisioning The Dash 4G comes with a pre-installed SIM card and is provisioned on our GPS tracking platform. Each device is checked for connectivity prior to being delivered to a client site. The device is not IP67 rated, so be cautious when ...

• Install Guide – AD Plus V2

  Device Provisioning The AD Plus V2 comes with a pre-installed SIM card and is provisioned on our GPS tracking platform, and video monitoring platform. The AD Plus V2 also come pre-installed with SD Card(s) for on-board video recording. Each device is ...